Start-Up; Requirements For Initial Commissioning; Overview Of The Operating And Display Elements - Parker Zander WVM 40 Operating Manual

EN | Operating manual

Start-up

Warning!
The dryer must be taken into operation by trained personnel only! Untrained
personnel does not have the required knowledge. Such personnel might cause
serious faults.
Note:
You can order the initial commissioning and start-up from the manufacturer
and have your personnel trained by the manufacturer. For telephone number,
see page 6.
◊ Carry out all prescribed tests and checks.
◊ Before start-up, ensure that no tools or other foreign parts have been left lying in a part of
the dryer where they might pose a hazard to the dryer being started up.

Requirements for initial commissioning

The following conditions must be met for initial commissioning:
◊ All pipelines are free of contamination.
◊ All shut-off valves are closed.
◊ The dryer has been properly set up, wired and connected.
◊ The compressors are ready for operation.
◊ At the outlet side, a compressed air consumer is present, i.e. compressed air can fl ow
through the dryer.
◊ Operators for the components are available.
Inspection to be carried out prior to commissioning
◊ all pipe, cable and screw connections have been retightened,
◊ none of the lines are worn at edge of the dryer body,
◊ all connections are properly secured,
◊ the electric connections are properly secured and in good condition,
◊ the operator-supplied components such as safety valves and other equipment holding
pressure are not blocked by dirt or paint,
◊ all components of the compressed air system that are under pressure (valves, hoses, etc.)
are free of wear or other defects,
◊ suffi cient amounts of required supply media such as steam or cooling water are available at
suitable quality and the respective shut-off valves are open.

Overview of the operating and display elements

The operating panel at the switch cabinet door allows for the monitoring of the operating sta-
tuses and for the modifi cation of settings. The display is a Touch Screen Panel. To operate,
touch the elements on the screen.
For further information on the operating panel and the controller's functions, please refer to
the enclosed controller manual.
30
Start-up
WVM 40 -1450