Cisco PA-2CE1 Series Installation And Configuration Manual page 36

Setting the PA-2CE1 Jumpers
Figure 3-4
Figure 3-5
Replace the plastic jumper cover over the 2CE1 jumpers and secure it to the port adapter printed circuit
Step 6
board using a number 1 Phillips screwdriver and the screws that you saved in Step 4.
Step 7 Replace the PA-2CE1 in the VIP2. See the "VIP2—Removing and Installing a Port Adapter" section on
page 3-6 for port adapter replacement procedures.
Replace the VIP2 in the chassis. To do so, follow the steps in the section "Installing a VIP2" in the
Step 8
configuration note Second-Generation Versatile Interface Processor (VIP2) Installation and
Configuration, which shipped with your VIP2.
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
3-10
2CE1 Balanced 120-Ohm Jumper Configuration (Bottom View of the PA-2CE1—Cover
Removed)
Port 0
J2 J8
J3
J7
J5
2CE1 Unbalanced 75-Ohm Jumper Configuration (Bottom View of the PA-2CE1—Cover
Removed)
Port 0
J2 J8
J3
J7
J5
Port 1
J14
J9
J13
J11
J4
J10
J15
J12
Port 1
J14
J9
J13
J11
J4
J10
J15
J12
Chapter
OL-3519-01