Configuring The Pa-2Ce1 Interfaces - Cisco PA-2CE1 Series Installation And Configuration Manual

Configuring the PA-2CE1 Interfaces

Configuring the PA-2CE1 Interfaces
After you verify that the new PA-2CE1 is installed correctly (the enabled LED goes on), use the
privileged-level configure command to configure the new interface. Have the following information
available:
•
•
•
•
•
•
Table 4-1
Keywords by Area
Australia
•
Europe
•
•
•
•
•
•
•
Japan
•
•
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
4-2
ISDN switch type, when configuring ISDN PRI (Table 4-1 lists ISDN service provider
switch types)
E1 information, for example, line code, framing type, and so on
Channel group and PRI group information and timeslot mapping
Protocols and encapsulations you plan to use on the new interfaces
Protocol specific information, such as internet protocol (IP) addresses, if you plan to configure the
interfaces for IP routing
Whether the new interface will use bridging
ISDN Service Provider
Switch Type
basic-ts013
Australian TS013 switches
basic-1tr6
German 1TR6 ISDN switches
basic-nwnet3
Norwegian NET3 ISDN switches (phase 1)
basic-net3
NET3 ISDN switches (UK, Denmark, and other
nations); covers the Euro-ISDN E-DSSI signaling
system).
basic-net5
NET5 switches (UK and Europe)
primary-net5
European ISDN PRI switches (UK and Europe)
vn2
French VN2 ISDN switches
vn3
French VN3 ISDN switches
ntt
Japanese NTT ISDN switches
primary-ntt
Japanese ISDN PRI switches
Chapter
OL-3519-01