Fehlersuche; Troubleshooting; Επίλυση Προβλημάτων - AEG UltraCaptic Instruction Book

Table of Contents

Advertisement

18

Troubleshooting

Der Staubsauger lässt sich nicht einschalten.
• Prüfen, ob das Netzkabel an die Netzsteckdose angeschlossen ist.
• Prüfen, ob der Stecker und das Kabel beschädigt sind.
• Prüfen, ob eine Sicherung durchgebrannt ist.
• Prüfen, ob Batterieanzeige reagiert (nur bestimmte Modelle). *
Schlauchverstopfung beseitigen
Verstopfung des Schlauchs durch Biegen und Beugen lockern und lösen. Dabei jedoch
vorsichtig vorgehen, falls die Blockierung durch Scherben oder spitze Gegenstände (z. B.
Nadeln) im Schlauch verursacht wurde.
Hinweis: Die Garantie deckt keinerlei durch Reinigung verursachte Schäden an den Schläuchen ab.
Wasser ist in den Staubsauger eingedrungen.
de
Es ist notwendig, den Motor in einem autorisierten AEG-Servicezentrum auszutauschen.
Schäden am Motor, die durch eingedrungenes Wasser verursacht wurden, werden nicht
durch die Garantie abgedeckt.
eng
Falls weitere Probleme auftreten, wenden Sie sich an die AEG Kundenbetreuung.
gre
Η ηλεκτρική σκούπα δεν λειτουργεί
• Βεβαιωθείτε ότι το καλώδιο είναι συνδεδεμένο με το ρεύμα.
• Βεβαιωθείτε ότι η πρίζα και το καλώδιο δεν παρουσιάζουν βλάβη.
• Ελέγξτε για καμένη ασφάλεια.
• Ελέγξτε εάν η ενδεικτική λυχνία της μπαταρίας ανταποκρίνεται (μόνο σε ορισμένα μοντέλα). *
Καθαρισμός του εύκαμπτου σωλήνα
Καθαρίστε τον εύκαμπτο σωλήνα "πιέζοντάς" τον. Ωστόσο, να είστε προσεκτικοί στην
περίπτωση που η απόφραξη έχει προκληθεί από γυαλιά ή βελόνες που έχουν πιαστεί μέσα
στον εύκαμπτο σωλήνα.
Σημείωση: Η εγγύηση δεν καλύπτει οποιαδήποτε ζημιά προκληθεί στους εύκαμπτους σωλήνες
ως αποτέλεσμα του καθαρισμού τους.
Έχει μπει νερό στην ηλεκτρική σκούπα
Θα πρέπει να γίνει αντικατάσταση του κινητήρα σε ένα εξουσιοδοτημένο κέντρο
εξυπηρέτησης της AEG. Τυχόν βλάβες του κινητήρα που προκαλούνται από διείσδυση
νερού δεν καλύπτονται από την εγγύηση.
Για τυχόν άλλα προβλήματα, επικοινωνήστε με ένα εξουσιοδοτημένο κέντρο εξυπηρέτησης
της AEG.
The vacuum cleaner does not start
• Check that the cable is connected to the mains.
• Check that the plug and cable are not damaged.
• Check for a blown fuse.
• Check if the battery indicator lamp responds. *
Clearing the hose
Clear the hose by "squeezing" it. However, be careful in case the obstruction has been
caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to hoses caused by cleaning them.
Water has entered the vacuum cleaner
It will be necessary to replace the motor at an authorized AEG service centre. Damage to
the motor caused by the penetration of water is not covered by the warranty.
For any further problems, contact an authorized AEG service centre.

Advertisement

Table of Contents
loading

Table of Contents