No
Parts
2
Controller
Procedure
6) Remove the 4 bolts on the panel corner
connected to the fan coil unit (use
+SCREWDRIVER)
7) Press inward the hanger on either side of the
panel while turning it 90 degrees to remove it
from the fan coil unit. Doing this will enable you
to remove the panel from the fan coil unit.
1) Remove the connector wire that is connected to
the fan coil unit controller.
2) Remove the 2 screws fixed on either side of the
electronics board to remove the board from the
fan coil unit (use +SCREWDRIVER)
3-19
Disassembly and Reassembly
Remark