No
Parts
8
CROSS FAN
Procedure
1) Remove the heat exchanger from the fan coil unit.
When turning on the cold/hot water after
replacing the heat exchanger, make sure
to open the air release valve to sufficiently
remove air from inside the coil and pipe by
collecting the water using the tube before
closing the valve. Failure to do so may
result in decreased performance and noise
generation.
1) Remove the 3 screws of the COVER FAN MOTOR
(use +SCREWDRIVER).
2) Remove the HOLDER FAN's screw (use
+SCREWDRIVER).
When reassembling, make sure that the
end of the HOLDER FAN coincides the face
of ASS'Y CROSS FAN_L.
3-16
Disassembly and Reassembly
Remark