About this task
The following image indicates the location of the rubber feet and provides a visual representation of the installation procedure:
Steps
1. Align the screw holes on the rubber foot with the screw holes on the display bezel.
2. Install the two screws (M3x5) that secure the rubber foot to the display assembly.
Next steps
1. Install the
middle
cover.
2. Install the speakers.
3. Install the VESA-mount.
4. Install the
system
board.
5. Install the
heat
sink.
6. Install the
wireless
card.
7. Install the
heat
sink.
8. Install the
solid-state
drive.
9. Install the
back
cover.
10. Install the stand.
11. Follow the procedure in
Display panel
Removing the display panel
Prerequisites
1. Follow the procedure in
2. Remove the
stand.
3. Remove the
back cover.
4. Remove the
Vesa-mount.
5. Remove the
speakers.
40
Removing and installing components
After working on your thin
Before working on your thin client.
client.