Siemens RUGGEDCOM RX1400 Installation Manual page 12

5
6
7
8
9
10
11
12
13
14
15
16
Figure 1.1
POWER LED
ALARM LED
CELL LED
Port Status LEDs
Access Plate
RS232 Serial Console Port
ANT Ports
Failsafe Alarm Relay
Power Supply Terminal Block
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13
Fast Ethernet Ports
ANT2 Port
SFP Transceiver Ports
Failsafe Alarm Relay
ANT3 Port
ANT4 Port
Power Supply Terminal Block
RS232 Serial Console Port (DB9)
ANT5 Port
POWER LED
ALARM LED
CELL LED
RUGGEDCOM RX1400
Illuminates when power is being supplied to the device.
Illuminates when an alarm condition exists.
Indicates when the cellular modem is connected to the network.
• Solid = Activity
• Off = No activity
Indicate the status of each port:
State
Solid
Blinking
Off
The removable access plate provides access to the Micro SD card
and SIM card slots.
• Use a Micro SD card to store the firmware and configuration for
the device
• Use a single or dual (recommended) SIM cards to connect to an
LTE network
The serial console port is for interfacing directly with the device and
accessing initial management functions. For information about con-
necting to the device via the serial console port, refer to
ing to the Device (Page 25)".
SMA ports for connecting to an LTE network or Global Navigation
Satellite System (GNSS). For more information, refer to:
• "Connecting the Antennas (Page 13)"
• "Cellular Modem Specifications (Page 36)"
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay (Page 21)"
• "Failsafe Alarm Relay Specifications (Page 35)"
A pluggable terminal block. For more information, refer to:
• "Connecting Power (Page 22)"
• "Power Supply Specifications (Page 35)"
Introduction
1.2 Description
Description
Link established
Link activity
No link/activity
"Connect-
3