Oregon CS1200-092 Original Instruction Manual page 29

SYMPTOM
Chainsaw does
not cut properly
Chain loosening
or coming off of
guide bar
Bar and chain
excessively hot
and/or smoking
Chainsaw Model CS1200-092
Troubleshooting
POSSIBLE CAUSE
Insufficient chain tension
Dull chain
Chain installed
backwards
Worn chain
Dry or excessively
stretched chain
Chain not in bar groove
Side cover not
installed correctly
Chain is under-lubricated
RECOMMENDED ACTIONS
Tension the chain. See "Tensioning the Saw Chain"
in the "Preparing for Use" section of the manual.
See "Sharpening the Saw Chain".
Install the chain with the teeth facing the correct
direction. See "Replacing a Worn Saw Chain".
Replace the chain. See "Replacing a Worn Saw
Chain".
Check the oil level. Refill oil reservoir if necessary.
See "Filling the Bar and Chain Oil Reservoir".
Reseat chain onto groove. See "Replacing a Worn
Saw Chain".
Properly install side cover ensuring the tab at rear
of side cover is tucked into saw body.
Check the oil level. Refill oil reservoir if necessary.
See "Filling the Bar and Chain Oil Reservoir".
29