Dubbing Images Stored In A Multimediacard To A Tape - THOMSON VMD 6 User Manual

46
EN
Power Switch
Recording
Start/Stop Button
Rewind Button (2)
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)
Display
T O C OP Y T
P US H S TA R
VMD6 EN(40/80)
Dubbing Images Stored In A
MultiMediaCard To A Tape
Images can be dubbed from a MultiMediaCard to a tape.
1
2
3
4
Lock Button
5
6
Fast-Forward
Button (3)
NOTE:
If the Recording Start/Stop Button is pressed in step 5 when
the tape's erase protection tab is set to "SAVE", the
message "COPYING FAILED" is displayed.
O T A P E
T / S T O P
R E C
4 4 4
46
DUBBING
Load a MultiMediaCard (
( pg. 10).
To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
Set the VIDEO/DSC Switch to "
2
Power Switch to " " while pressing down the
Lock Button located on the switch.
To select a still image to be dubbed, perform Index
3
Playback ( pg. 35) or press 2 or 3 to select the
image you wish.
To engage Dub-Standby, press the Recording Start/
Stop Button. The message "TO COPY TO TAPE PUSH
START/STOP" appears.
While the message is being displayed, press the
Recording Start/Stop Button. The selected still image
is recorded on the tape for approx. 5 seconds.
•The indicator disappears when dubbing is
complete.
28/08/00, 16:07
(cont.)
pg. 11) and cassette
", then set the