THOMSON VMD 6 User Manual page 8

1
3
ATTENTION:
Before detaching the power source,
make sure that the camcorder's power
is turned off. Failure to do so can result
in a camcorder malfunction.
USING AC POWER
Use the AC Power Adapter/Charger (connect as shown in the illustration).
NOTES:
The provided AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to
240 V.
For other notes, pg. 6.
VMD6 EN(02/39)
USING THE BATTERY PACK
1
Tilt the viewfinder upward
BATTERY RELEASE
Button
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against the
battery pack mount
pack until it locks in place
2
•If the battery pack is attached with its
To Detach The Battery Pack . . .
.... tilt the viewfinder upward
up slightly while pressing BATTERY RELEASE to detach it.
Approximate recording time
Battery pack
BAT 600
( ) : when the video light is on.
NOTES:
Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
To DC Input
connector
DC cord
7
1
.
2
, then slide down the battery
3
.
in the wrong direction, a malfunction may occur.
1
and slide the battery pack
LCD monitor on/
Viewfinder off
1 hr.
(35 min.)
Power cord
AC Power
Adapter/Charger
28/08/00, 15:46
7
E N
mark set
LCD monitor off/
Viewfinder on
1 hr. 15 min.
(40 min.)
To AC outlet
To DC OUT
connector