Recording; Basic Recording For Video - THOMSON VMD 6 User Manual

14
EN
Power Switch
Power lamp

Recording

Start/Stop Button
Display
2 5
min 90 min 89 min
(Now calculating)
0 min
(Blinking)
Tally lamp
(lights while recording
is in progress)
+
BR I GHT –
180 90
PUSH OPEN Button VIDEO/DSC Switch
VMD6 EN(02/39)
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Lock Button
1
2
During
shooting
Tape remaining
3
time indicator
(Approximate)
To Stop Recording . . .
3 min
.... press the Recording Start/Stop Button. The camcorder
2 min
1 min
(Blinking) (Blinking)
To Adjust The Brightness Of The Display
.... rotate MENU/BRIGHT until the bright level indicator
MENU/
BRIGHT Wheel
14

Basic Recording For Video

Power ( pg. 6)
Grip Adjustment ( pg. 8)
Viewfinder Adjustment ( pg. 8)
Load A Cassette ( pg. 10)
Recording Mode Setting (
Press in the tabs on the lens cap to remove it. Press
PUSH OPEN, open the LCD monitor and set the
VIDEO/DSC Switch to "VIDEO".
Set the Power Switch to "
down the Lock Button located on the switch.
Shooting while using the LCD monitor: Make sure
the LCD monitor is fully open. Tilt it upward/
downward for best viewability.
Shooting while using the viewfinder: Close the LCD
monitor.
•The power lamp lights and the camcorder enters the
Record-Standby mode. "PAUSE" is displayed.
Press the Recording Start/Stop Button. "
while recording is in progress.
re-enters the Record-Standby mode.
on the display moves and the appropriate brightness is
reached.
28/08/00, 15:47
pg. 12)
" or " " while pressing
" appears