Dubbing Images Stored In A; Multimediacard To A Tape - THOMSON VMD 22 User Manual

64
EN
Rewind Button (2)
Fast-Forward Button (3)
SNAPSHOT Button
Display
T O C OP Y T
P US H " SN A
VMD22 EN(34/65)

Dubbing Images Stored In A

MultiMediaCard To A Tape

Images can be dubbed from a MultiMediaCard to a tape.
1
POWER Switch
2
Lock Button
3
4
5
6
O T A P E
PS H O T "
NOTES:
64
DUBBING
Load a MultiMediaCard (
( pg. 10).
Set the POWER Switch to "
down the Lock Button located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
To locate the point where you wish to dub a still
2
image, play back the tape. Stop playback at the
desired point.
Set the POWER Switch to "
3
down the Lock Button located on the switch. To
select a still image to be dubbed, perform Index
Playback ( pg. 47), Auto Playback (
press 2 or 3 to select the image you wish.
To engage Dub-Standby, press SNAPSHOT. The
message "TO COPY TO TAPE PUSH "SNAPSHOT""
appears.
While the message is being displayed, press
SNAPSHOT again. The selected still image is
recorded on the tape for approx. 6 seconds.
•The indicator disappears when dubbing is
complete.
If SNAPSHOT is pressed in step 5 when the tape's erase
protection tab is set to "SAVE", the message "COPYING
FAILED" is displayed.
The XGA image is dubbed onto the tape at 720 x 480
pixels.
You can superimpose a snap frame over the selected still
image to be dubbed ( pg. 51) and dub it to a tape.
After step 4, superimpose a snap frame over the still
image and go to step 5.
29/08/00, 15:16
(cont.)
pg. 12) and cassette
" while pressing
" while pressing
pg. 45) or