User Maintenance - THOMSON VMD 6 User Manual

USER MAINTENANCE

After Use
1
Turn off the camcorder.
2
Slide and hold OPEN/EJECT in the direction of
the arrow, then pull the cassette holder cover
open until it locks. The cassette holder opens
automatically. Remove the cassette.
3
Press "PUSH HERE" to close the cassette holder.
•Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette holder cover.
4
Press BATTERY RELEASE and remove the battery
pack.
Cassette holder
PUSH HERE
VMD6 EN(40/80)
Cleaning The Camcorder
1
2
3
4
5
6
Remove.
NOTES:
OPEN/EJECT
Switch
Cassette holder
cover
BATTERY
RELEASE Button
65
To clean the exterior, wipe gently with a soft
cloth.
Put the cloth in diluted mild soap and wring it
well to wipe off heavy dirt. Then wipe again
with a dry cloth.
Press PUSH OPEN and open the LCD monitor.
Wipe gently with a soft cloth. Be careful not to
damage the monitor. Close the LCD monitor.
To clean the lens, blow it with a blower brush,
then wipe gently with lens cleaning paper.
To clean the viewfinder, raise it to the vertical
position. Carefully open the cover on the
bottom of the viewfinder
Insert a lens blower or soft cloth into the gap at
the bottom of the viewfinder and clean the
interior of the viewfinder with it
Close the cover. Tilt the viewfinder back to the
horizontal position.
Avoid using strong cleaning agents such as benzine
or alcohol.
Cleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
Mould may form if the lens is left dirty.
When using a cleaner or chemically treated cloth
refer to the cautions of each product.
Cover
Lens blower
28/08/00, 16:08
65
EN
1
.
2
.
1
2