Brandt VS1010X Instruction Manual page 19

Remarks:
- After each cyc le, c heck for any deb ris in the filte r to avoid future b lock age.
- By unscrew ing the coarse filter, you can rem ove the filter system . Re move any foo d remna nts and
clean the filters under running water.
The entire filter assembly should be cleaned once a week.
Cleaning the Filter
To clea n the coarse filte r an d the fine filt er, u se a clea ning brush. Rea ssem ble the filte r parts (see page 16)
and reinsert the m in the dish was her, pos ition ing them in their sea t and pressing downw ards.
The control pane l can be clea ned by using a lightly dampened cloth.
After cleaning, m ake sure to dry it thoroug hly.
For the exterior, use a good appliance polish w ax.
Never use sharp objects, scouring pads or harsh cleaners on a ny part of the dishwasher.
Cleaning the Door
Winterizing
please take frost protection measures on the dishwasher in winter. Every
please operate as follows
1 .Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remov e the filt er at the bottom of the tub and use a sponge to soak up water in the sump.
I f your dishwasher cannot work because of the ice,
please contact professional service persons.
Cleaning the Spray Arms
It is necessary to clean the spra y arms re gularly fo r hard
w ate r che micals w ill clog the sp ray arm jets a nd bearings.
To remove the up per spray arm, hold the nut, rotate the arm
clockwise to remove it.
To remove th e lower spray arm, pull out the spray arm u pwa rd.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
When cle anin g the filters, do no t kno ck them. Othe rwis e, th e filters could be c onto rted
and the p erfo rmance of the dish was her could be d ecre ase d.
To cle an the edge around the door,
cloth.
To avoid pene tration o f water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never u se a spray cleaner to clean the door panel as it m ay dam age the door loc k
and electrical components.
Abrasive ag ents or som e paper towels shou ld not be used becau se of the risk of
scratching or leaving spots on the stainless steel surface.
：
you sh ould only use a s oft, ward and damp
time a fter washing cycles,