The Dishw As Her - Brandt VS1010X Instruction Manual

When you press the Start/Pause button to pause during washing, the
stop blinking and the dishwasher will mooing every minute unless you press the
Start/Pause button to start.
Changing the Program Mid-Cycle
Premise:
1
A run ning cycle can only be changed if it has only been running for a short time .Otherwise, the detergent may have
alrea dy been released, and the appliance may have already drain the wash water. If thi s is the case, the detergent
dispenser must be refille d(see the section entitled Function of Detergent).
2 Press the Start/Pa use button , the machine will pause, press the program button more than 3s then you
can chan ge th e pro gram to the desired cycle setting (see the section entitled " Sta rting a washing program " ).
If you open the door
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the selected
program
A forgotten dish can be added any time before the detergent cup opens.
1
Press the Start/Pause Button to stop the washing.
2
Open the door a little .
3
After the spray arms stop working, you can open the door
completely.
When the wo rking cycle has finished, the buzzer of the dishwasher will soun d for 8 seconds, then stop. Turn off
the appliance using the O N/O FF button, shut off the wa ter supp ly and open the door of the dishw ashe r.
Wait for a few minutes before unlo ading th e dishwasher to avoid ha ndlin g the dishes and utensils while th ey
are still hot and m ore susceptible to break . They will also dry be tter.
Switching Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Open the door.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal for the dishw asher to be wet insid e.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
It is dangerous to open the door mid-cycle,
as hot steam may scald you.
during a wash cycle
after the power cut .
s hocks. The dishes should cool down for around 15
, the machine will pause. The program light will
Add forgotten dishes.
4
5
Close the door
6
Press the Start/Pause Button
after 10 seconds.
minutes
running indicator will
, the dishwasher will run