Waeco MagicWatch MW650 Installation And Operating Manual page 36

MW-650-4DSM.book Seite 36 Dienstag, 16. Mai 2006 4:28 16
Installing MagicWatch
The distance from the sensors to the ground must be between 40 cm and
50 cm (see fig. 10, page 6).
The horizontal alignment of the sensors must be 0° (see fig. 10, page 6).
Fit the sensors at regular intervals along the total width of the vehicle in
order to guarantee the optimum monitoring.
The assembly procedure is as follows:
➤ Select a fitting position under the bumper which is as parallel as possible
to the road surface (see fig. 12, page 6).
➤ Place the rubber plate (see fig. 4.6, page 4) between the sensor and the
bumper.
➤ Screw the sensors to the bumper using the nuts and bolts supplied.
6.3 Laying the sensor extension cables
When laying cables, ensure that:
They are not kinked or twisted
They do not rub on edges
They are not laid in sharp edged ducts without protection (see fig. 3,
page 4).
The plugs must be connected with the correct polarity. A blocking pin pre-
vents reverse polarity (see fig. 13 A, page 6).
Make sure the locking pin catches (see fig. 13 A, page 6). Only then is
trouble-free operation guaranteed.
To release the connection press the holder and pull the plug and socket
apart (see fig. 13 B, page 6).
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCS-1) as accessories.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics to
ensure that the display is correct.
36
MagicWatch MW650