Installing Magicwatch - Waeco MagicWatch MW650 Installation And Operating Manual

MW-650-4DSM.book Seite 35 Dienstag, 16. Mai 2006 4:28 16
MagicWatch MW650
6

Installing MagicWatch

6.1 Tools required
For installation and assembly you require the following tools:
Drill bit set (see fig. 1.1, page 3)
Drill (see fig. 1.2, page 3)
Screwdriver (see fig. 1.3, page 3)
Set of ring or open-ended spanners (see fig. 1.4, page 3)
For making and testing the electrical connection the following tools are
required:
Diode test lamp (see fig. 1.5, page 3) or Voltmeter (see fig. 1.6, page 3)
Crimping tool (see fig. 1.7, page 3)
Insulating tape (see fig. 1.8, page 3)
Cable bushing sleeves, if required
To secure the controller and the cable you may require additional screws
and cable binders.
6.2 Fitting the sensors
The sensors must be correctly aligned for the device to work.
If these point to the ground, bumps in the ground may be inter-
preted as obstacles. If they point too far up, obstacles will not be
detected.
Note the following information during installation:
The maximum range is around 2,5 m for the visual display and 1.5 m for
the audible display.
So that the corners of the vehicle (indicator lights etc.) can be monitored,
the sensor should not be fitted more than 0.3 m away from them.
The sensor may only be fitted under the bumper (see fig. 12, page 6). If it
is fitted upside-down, it will detect the ground.
Installing MagicWatch
35