Waeco MagicWatch MW650 Installation And Operating Manual page 33

MW-650-4DSM.book Seite 33 Dienstag, 16. Mai 2006 4:28 16
MagicWatch MW650
Only use WAECO cables (MWCS-1).
Otherwise, proper operation cannot be guaranteed.
Defective sensors can be replaced without removing the bumper. There is a
plug connector just behind the sensor for this.
5.2 Detection range
The detection range of MagicWatch is divided into four zones (see fig. 5,
page 5):
Zone 1
This zone is the detection range for large objects, such as cars. Small or
poorly reflective objects may not be detected in some circumstances. The
distance is signalled audibly and using the numerical display.
Zone 2
Small or poorly reflective objects are sometimes not detected in this zone.
Other objects are signalled both visibly and audibly.
Zone 3
Nearly all objects are displayed in this zone.
Zone 4
Nearly all objects are displayed in this zone, but some objects may come
into the blind spot of the sensors.
Situations may arise where MagicWatch does not detect objects
or fails to signal their distance correctly, due to their physical char-
acteristics.
Note the four following examples.
Example 1 (see fig. 6, page 5)
Objects which do not enter the detection area of the sensors cannot be
recorded.
Example 2 (see fig. 7, page 5)
The distance to objects with large gaps in them may not be correctly sig-
nalled. In the example, A is not signalled, but only B or C instead.
Technical description
33