Carton Contents - Electrolux Flymo Twist 'N' Edge 250 Manual

1
Handle
Knob
Nut (if applicable)
Steady Handle
IMPORTANT !
Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY PARTS ARE MISSING CONTACT:-
Electrolux Outdoor Products Customer Service Department direct
Telephone : 01325 300303
Fax : 01325 318193
If not used properly this trimmer can be dangerous! This trimmer can cause serious injury to the oper-
ator and others, the warnings and safety instructions must be followed to ensure reasonable safety
and efficiency in using this trimmer. The operator is responsible for following the warning and safety
instructions in this manual and on the trimmer.
Explanation of Symbols on the Twist n Edge
Warning
Read the user instructions carefully to
make sure you understand all the con-
trols and what they do.
Keep others, including children, pets and
10m
bystanders outside the 10 metre hazard
zone. Stop the trimmer immediately if you
are approached.
General
1. Never allow children or people unfamiliar with these
instructions to use the trimmer. Local regulations
may restrict the age of the operator.
2. Only use the trimmer in the manner and for the
functions described in these instructions.
3. Never operate the trimmer when you are tired, ill or
under the influence of alcohol, drugs or medicine.
4. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
All manuals and user guides at all-guides.com

Carton Contents

Upper Shaft
Lower Shaft
Washer
Instruction
Bolt Manual
Safety
Pivot Block
The use of eye protection is recommend-
ed to protect against objects thrown by
the cutting line.
To avoid the possibility of electric shock,
do not use in damp or wet conditions.
Switch off! Remove plug from mains
before adjusting, cleaning or if cable is
entangled or damaged.
Warning: The cutting line continues to rotate after the
machine has been switched off.
Electrical
1. The British Standards Institute recommend the use
of a Residual Current Device (R.C.D.) with a trip-
ping current of not more than 30mA. Even with a
R.C.D. installed 100% safety cannot be guaranteed
and safe working practice must be followed at all
times. Check your R.C.D. every time you use it.
2. Before use, examine cable for damage, replace it if
there are signs of damage or ageing.
3. Do not use the trimmer if the electric cables are
damaged or worn.
Switch Lever
Electric Cable with
moulded on plug
Safety Guard