Table of Contents
Advertisement
3
A
1
B
2
C
D
E
F
All manuals and user guides at all-guides.com
Assembly Instructions
2
2
1
1
3
4
pivot block
Cable Restraint
G
Shaft Assembly (A)
1. Locate the lower shaft (A1) into the upper
shaft (A2).
2. Grasp firmly and hold steady the lower shaft.
Locate the upper shaft and snap together
firmly.
•
The unit is correctly assembled when the
gap between the upper and lower shaft
has been closed.
Safety Guard Assembly (B) & (C)
1.
Align the arrow on the top of the safety guard
(B1) with the arrow on the side of the trimmer
(B2).
2.
Locate the safety guard (B3) over the cutting
head (B4). Ensure the nylon lines are fed
through the hole in the safety guard as illus-
trated in fig B.
3.
Push into location and turn safety guard in
the direction illustrated in Fig C, until a click
is heard and the safety guard is securely
locked in position.
•
ENSURE THE SAFETY GUARD IS
SECURELY IN PLACE BY ATTEMPTING
TO TWIST GUARD IN OPPOSITE DIREC-
TION.
Steady Handle Assembly (D) & (E)
1.
Place bolt through hole in underside of steady
handle (figure D).
2.
Push bolt through holes in pivot block (Figure E).
3.
Insert nut into handle knob (if applicable)
4.
Hold bolt in position with finger then fit wash-
er and handle knob. Tighten handle knob (do
not overtighten).
•
To adjust steady handle to new position,
loosen handle knob and move handle to most
comfortable operating position. Re-tighten
handle knob.
Cable Restraint (F) & (G)
1.
Form loop in mains cable and push the loop
through the slot as illustrated in picture (F).
2.
To secure, position loop over the hook and
pull the cable back through the slot as illus-
trated in picture (G).
Advertisement
Table of Contents
