Table of Contents
Advertisement
MAINTENANCE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the exercise cycle
regularly. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console or the pulse
monitor. Keep the console out of direct sunlight or the
display may be damaged. Remove the battery when
storing the exercise cycle.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced (see assembly step 1 on page 5).
Note: It will be necessary to remove the console to
replace the batteries.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle
does not sit flat on
the floor, try turning
one or both of the
Adjustable Endcaps
(25) at the front of the
exercise cycle until
the exercise cycle is
level.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Left Side Shield (24) and the Flywheel
Cover (31) must be removed. Using an adjustable
wrench, turn the Left Pedal (20) clockwise and remove
it. Next, remove the indicated Screws (2, 32, 35, 49).
Turn the Crank (70) to the position shown and slide off
the Left Side Shield and the Flywheel Cover.
24
70
32
20
2
35
49
35
All manuals and user guides at all-guides.com
25
31
10
Next, locate the Reed Switch (4). Turn the crank until
the Magnet (33) is aligned with the Reed Switch.
Loosen but do not remove the indicated Screw (35).
Slide the Reed Switch slightly closer to or away from
the Magnet. Retighten the Screw. Turn the Crank for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, re-attach the left side shield, flywheel cover and
left pedal.
35
33
4
70
Front View
Advertisement
Table of Contents
