Table of Contents
Advertisement
IC Live Users Manual, ICL-F & ICL-F-DUAL
INSTALLATION
PRE INSTALL TEST
It's always a good idea to test the column array as a complete unit before it is installed to make sure all the connections were properly made
and all the transducers are working. If there is a problem, its a lot easier to find and correct before the unit is physically installed.
Use one of the 3-pin connectors supplied with the assembly to connect audio to the loudspeaker and the power cord to connect the power.
You do not need the digital control cable to conduct a simple audio test.
Notice that these connections can be made inside any one of the access chambers. This Iconyx feature gives you a choice of where the
audio and digital control connections are made. You can, for example, bring the audio into the bottom module and the digital control lines
into the top module.
CABLING REQUIRED
POWER
Your Iconyx column was supplied with a 6-foot AC Power cord with IEC connectors.
Note that the column(s) do not include a power on/off switch and you will have to make sure an external power on/off switch is provided.
Each module, however, does include a self-restoring circuit breaker as protection against damage in the event of an internal failure.
Power requirements for Iconyx columns are listed below.
ICL-F and ICL-F-DUAL:
WARNING:
1. The AC mains must be connected to a mains socket outlet with a protective earthing
connection.
2. To remove power from the Iconyx column, disconnect the AC power cord.
3. If the knockout on the rear cover is used during installation, a means of preventing
damage to the AC power cord must be provided.
AUDIO & DIGITAL CONTROL LINES
A block diagram of a simple four column system follows. Note that the RS422 digital control cable loops from column to column. RS422 is a
"daisy-chain" bus system and should not be wired as a star or branching network. The audio signal cable is also shown looping from column
to column, but it may be star or branch wired.
RS422 Contol Cable
From Audio Source
All manuals and user guides at all-guides.com
Universal 100/240 VAC, 50/60 Hz; 150 Watts each module.
Audio Cable
32
Advertisement
Table of Contents
