Table of Contents
Advertisement
2-1. Cleaning of Connector/Cable
It is recommendable to clean the optical contact portions
mentioned below before connecting this unit to the camera
control unit.
. CCU connector of this unit
. Camera connector of the camera control unit
. Optical/Electrical cable
It is also necessary to clean the optical contact portions
mentioned below before using the HDC-F950 to the large
lens adaptor CA-905L.
. CA cable of a large lens adaptor
. CCU connector of a large lens adaptor
Follow the procedures below for cleaning.
When the Optical Connector Cleaner
(Commercially Available) is Available:
Tools required
. Optical connector cleaner (commercially available)
Product name: CLETOP
®
14100402 or 14100403 (stick type) or equivalent
14100402: 2.0 mm
14100403: 2.0/2.5 mm. The cleaner type having cleaning
points at both ends.
m
. Alcohol is not necessary during cleaning.
. Number of possible wipes is one cleaning per a piece.
Do not reuse it.
Supplier:
NTT-ME Corporation
HIKARI Business Department
Global Solution Headaquarters
Tel:
81-3-5956-9025
Fax: 81-3-5956-9039
e-mail: opt-g@ntt-me.co.jp
URL:
http://nttiivs.ntt-me.co.jp/opt-e/
HDC-F950 IMM
Section 2
Service Overview
Cleaning procedure
[Male connector]
Clean the tip of the white optical contacts using the optical
connector cleaner.
[Female connector]
1. Insert the optical connector cleaner straight. Ensure
that it is held straight when inserting.
2. Apply sufficient pressure (approximately 600 g to 700
g) to ensure that the optical contact is a little de-
pressed.
3. While pressing the optical connector cleaner against
the tip of the optical contact, rotate the optical connec-
tor cleaner by 4 to 5 turns clockwise. Holding the
optical connector cleaner at around its support facili-
tates to apply the pressure.
Optical contacts (white)
Alignment sleeve
Optical connector cleaner
Support
Optical contacts (white)
2-1 (E)
Advertisement
Table of Contents
