Using Nonfading Output; Adjusting Nonfading Output Level; Using The High Pass Filter - Pioneer DEH-P70BT Operation Manual

Section
14 Audio Adjustments
# When the subwoofer output is on, you can se-
lect Sub-W2.
2 Push Multi-Control left or right to select
cut-off frequency.
Each time Multi-Control is pushed left or
right, cut-off frequencies are selected in the
following order:
50Hz80Hz125Hz
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push Multi-Control up or down to ad-
just the output level of the subwoofer.
Each time Multi-Control is pushed up or
down, subwoofer level increases or decreases.
+6  6 is displayed as the level is increased
or decreased.

Using nonfading output

When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Use Multi-Control to select nonfading
output on/off setting.
ON appears in the display.
# When the subwoofer controller setting is only
Preout :FULL, you can switch to the nonfading
output on/off setting. (Refer to page 80.)
2 Press Multi-Control to turn nonfading
output on.
ON appears in the display. Nonfading output
is now on.
# To turn nonfading output off, press
Multi-Control again.
76
En
All manuals and user guides at all-guides.com

Adjusting nonfading output level

When the nonfading output is on, you can ad-
just the level of nonfading output.
1 Use Multi-Control to select nonfading
output setting.
0 appears in the display.
2 Push Multi-Control up or down to ad-
just the nonfading output level.
Each time Multi-Control is pushed up or
down, the level of the nonfading output in-
creases or decreases. +6  6 is displayed as
the level is increased or decreased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Use Multi-Control to select HPF.
HPF appears in the display.
2 Press Multi-Control to turn high pass fil-
ter on.
80Hz appears in the display. High pass filter is
now on.
# To turn high pass filter off, press
Multi-Control again.
3 Push Multi-Control left or right to select
cut-off frequency.
Each time Multi-Control is pushed left or
right, cut-off frequencies are selected in the
following order:
50Hz80Hz125Hz
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.