Using Subwoofer Output; Adjusting Subwoofer Settings; Using Nonfading Output - Pioneer DEH-P80MP Operation Manual

Audio Adjustments
3 Push Multi-Control left or right to select
a desired level.
Each pushing Multi-Control left or right se-
lects level in the following order:
LOW (low)MID (mid)HIGH (high)
4 To turn loudness off, press
Multi-Control again.
Loud OFF appears in the display.

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
1 Use Multi-Control to select Sub-W1.
Sub-W1 appears in the display.
# When the subwoofer controller setting is
PREOUT:FULL, you cannot select Sub-W1.
2 Press Multi-Control to turn subwoofer
output on.
Sub-W1 Normal appears in the display. Sub-
woofer output is now on.
# To turn subwoofer output off, press
Multi-Control again.
3 Push Multi-Control left or right to select
the phase of subwoofer output.
Push Multi-Control left to select reverse
phase and Rev. appears in the display. Push
Multi-Control right to select normal phase
and Normal appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use Multi-Control to select Sub-W2.
Sub-W2 appears in the display.
# When the subwoofer output is on, you can se-
lect Sub-W2.
2 Push Multi-Control left or right to select
cut-off frequency.
Each pushing Multi-Control left or right se-
lects cut-off frequencies in the following order:
5080125 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push Multi-Control up or down to ad-
just the output level of the subwoofer.
Each pushing Multi-Control up or down in-
creases or decreases the level of the subwoo-
fer. +6  6 is displayed as the level is
increased or decreased.

Using nonfading output

When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Use Multi-Control to select nonfading
output on/off setting.
NonFad ON appears in the display.
# When the subwoofer controller setting is only
PREOUT:FULL, you can switch to the nonfading
output on/off setting. (Refer to page 62.)
2 Press Multi-Control to turn nonfading
output on.
NonFad ON appears in the display. Nonfading
output is now on.
# To turn nonfading output off, press
Multi-Control again.
Section
12
57
En