Related Manuals for Pro's Pro Electronic SX-01
Summary of Contents for Pro's Pro Electronic SX-01
- Page 1 Electronic SX-01 Stringing Machine User’s Manual Attention: Please read this manual carefully before operating with the machine. Keep it properly for the aftersales service. Page 1...
-
Page 2: Table Of Contents
Catalogue 1. Attentions Operating attentions Safe using attentions 2. Unpacking and inspection Components Inspection 3. Operating Instructions 4. Mounting a racket 5. Insert a string 6. Adjusting the base of the swivel clamp 7. Maintance 8. Troubleshooting 9. Service Guide 10. - Page 3 Safety precautions Following are fatal informations for your safety, please observe strictly. “ ” Warning mark – Any information in this manual with a warning mark must be abided by strictly, otherwise there will be danger of the personal safety or could lead to a significant accident.
-
Page 4: Unpacking And Inspection
Set of Allen wrench 2.2 Unpack the machine carefully and inspect the Electronic SX-01 stringing machine for any obvious damage. Check if all parts are included in the carton. If any item is missing or damaged, contact your delivery agent and your sales representative. -
Page 5: Operating Instructions
3. Operating Instructions 1. Place the machine on a table or a stand foot. 2. On the back side of the electronic tension there is a switch which should be in the ON position for normal operation. 3. Turn the power on and a green light flashes and the tension strength appears on the LED display. -
Page 6: Mounting A Racket
7. If the engine doesn’t stop pulling automatically, press the backwards button. 8. After stringing turn the machine off. 9. Turn the tension on the display down to 10 kilogram the tension in the machine should be as low as possible in the time of not stringing. 4. -
Page 7: Insert A String
5. How to put the string into the tension system First place the string over the small reel and then around the big one and place it into the slot and hold the string down. Then push the button to 1 and the machine starts pulling until it has the right tension. -
Page 8: Maintance
7. Maintenance 1. The Electronic SX-01 stringing machine is adjusted and calibrated before shipment. Working is easy and relatively maintenance-free. 2. Keep the stringing machine always at a dry and safe place. Keep it away from dust, grease, moisture and any type of heat. -
Page 9: Service Guide
The string clamp does not hold the string: Clean the jaws of the string clamp. Use the large dial to adjust the distance between the jaws. Adjust the distance according to the thickness of your tennis string. The clamp can also be fine-adjusted. On the opposite side of the dial there are 2 small Allen screws (2.5 mm). -
Page 10: Calibration
11. Calibration The machine is calibrated with an electronic Tension calibrator, if you have only a mechanic one, please be sure that it is not too old otherwise the spring inside will give you wrong results. 1. Set the tension to 30 kg 2. - Page 11 press right button for starting stringing the line after pressing this button the display switches to 20,5kg, now push the up/down button as long as the multimeter (tension calibrator) is 30kgs, then press the KG/LB button and ---OK-----loose the line---finish! (no matter what is shown on the display of the engine!) Page 11...