Table of Contents
Advertisement
Quick Links
Infrared Electric Umbrella Heater
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT
ACCESSIBLE PARTS MAY BE VERY HOT. KEEP YOUNG CHILDREN AWAY.
Minimum clearance from combustible materials: 1 metre
Important: Retain these instructions for future use
4150-05/15
Model No. GM135-017
FOR OUTDOOR USE ONLY
OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET
PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE
OPERATE THE APPLIANCE INDOORS
OPERATE IN AN ENCLOSED AREA
.
Advertisement
Table of Contents
Related Manuals for Gasmate GM135-017
Summary of Contents for Gasmate GM135-017
- Page 1 Infrared Electric Umbrella Heater Model No. GM135-017 FOR OUTDOOR USE ONLY DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE...
-
Page 2: Safe Operation
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS Safety Installation Before attempting to operate this heater, the Always ensure you use the correct fixing method following basic safety precautions should be found in the mounting instructions on page 4. This taken to reduce the risk of fire, electric shock heater is not designed for use within 1m or above and personal injury. -
Page 3: Specific Safety Instructions
SPECIFIC SAFETY INSTRUCTIONS WARNINGS Do not use the heater in areas where there is a • DO NOT expose the heater to rain, water, or risk of explosion or fire from flammable gases. use in damp wet conditions. Ensure that the heating area is kept clear of •... -
Page 4: Electrical Data
MOUNTING THE HEATER consult a qualified electrician. Step 1 Technical Specification Ensure umbrella is secure and stable by using a suitable umbrella base. Model GM135-017 Step 2 Voltage: 220V-240V~ 50Hz Place heater on the umbrella pole. Input Wattage: 1500W Step 3 Unit Weight: 3.5Kg... -
Page 5: Positioning The Heater
POSITIONING THE HEATER REPLACING THE BULB When choosing a mounting position, it is 1. Unplug the unit. important to ensure the heater beams are NOT 2. Loosen the screw at the top of the unit and pointed towards combustible surfaces. To adjust, hinge the front open. - Page 6 This page has been left intentionaly blank...
- Page 7 This page has been left intentionaly blank Gasmate ® is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au Aber, Hamilton, N.Z. www.gasmate.co.nz...