Advertisement
10. Hand turn flywheel towards you
to check spreader device
movement and lower needles.
Thread in the following sequence:
1. brown thread for chain looper
2. blue thread for L0 needle
3. red thread for L1 needle
4. yellow thread for L2 needle
5. green thread for spreader
device (see below)
NOTE: The needle threads should be
separated in the last two guides with
the blue to the far left, then red and
finally yellow.
Spreader Device Threading
Use Green tension disc and thread
through all five guides shown in
illustration.
There are three holes on the lower
right side of the take-up lever cover.
Change the threading position
according to the thread type.
−
Upper hole: Stretch deco
thread (Woolly Nylon®)
−
Middle hole: Standard
overlock thread.
−
Lower hole: Deco non-
stretchable thread
6
Advertisement
