Functions Using Memo (A, B) Points; Setting Memo Points; Locating Memo Points; Confirming The Time Of Memo Points - Tascam RC-601mkII Owner's Manual

FUNCTIONS USING MEMO (A, B) POINTS

You can automatically stop at certain points in playback
between two points or in rehearsal playback by setting
memo points (A and B) in advance.
In the program playback mode, functions using the
memo points described below cannot be used. (Memo
points cannot be set or located.) Also, the remote control
unit cannot be set to the program playback mode while in
the memo mode.

Setting Memo Points

1 In the monitor PAUSE mode, use the JOG/DATA dial to
search for the desired position to set.
2 Press the SET key to set the remote control unit to the
set mode. (The indicator lights.)
3 Press the A (or B) key. This sets the A (or B) point.
When a point is set, the indicator on the key lights, and
the SET indicator goes out.
[NOTE]
• If you set the remote control unit to the set mode in
advance by using the SET key (the SET indicator lights),
you can set points by pressing the A (or B) key at the
desired point in the monitor playback mode (or monitor
PAUSE mode).
• When a point is already set, it will be overwritten by the
new point.
If the CD-601MKII is turned OFF or the disc is removed,
all preset memo points will be cleared.
If you save memo points to memory on the CD-601MKII as
disc information, you can call them when you load the same
disc later on. (→ page 23 "Saving Disc Information")

Locating Memo Points

1 Press the RCL key.
The RCL indicator lights.
2 Press the A or B key (that is preset with a memo point).
The preset point is located, and the remote control unit
enters the online READY mode. (The RCL indicator goes
out.)
Confirming the Time of Memo
Points
There are two ways of confirming memo point times.
Method 1
1 While disc operations are stopped or in the monitor
PAUSE mode, press the MEMO key to set the remote
control unit to the memo mode. (The MEMO indicator
lights.)
2 Press the key (A or B) of the memo point to confirm.
The indicator corresponding to the key you pressed
blinks, and the time of the memo point is displayed in the
display window.
3 After checking the time, press the key of the memo point
again.
The indicator corresponding to the key you pressed
stops blinking and lights, and the regular time display is
returned to.
4 Press the MEMO key to exit the memory mode. (The
MEMO indicator goes out.)
Method 2
In the memo mode (while the MEMO indicator is lit), each
press of the CHECK key displays the current time of points
A and B.

Clearing Memo Point Settings

There are two ways of clearing currently set memo points.
Method 1
1 While disc operations are stopped, press the SET key
to set the remote control unit to the set mode. (The
indicator is lit.)
2 Press the key (A or B) of the memo point whose settings
are to be cleared.
This clears the memo point settings, and the indicator of
the memo point goes out.
The SET indicator goes out.
Method 2
1 In the memo mode (while the MEMO indicator is lit),
press the CHECK key until the memo point whose
setting is to be cleared is displayed in the display
window.
2 Press the CLR key.
This clears the memo point settings, and the indicator of
the memo point goes out.
19
TASCAM RC-601MKII