Setting The Brightness Of The Backlight (Dimmer); Restoring Default Settings (Initialize); Formatting The Sd Card; Setting The Main Battery Source (Main) - Tascam DR-100 Owner's Manual

10–Settings and Information
Setting the brightness of the
backlight (DIMMER)
You can set the brightness of the backlight.
1 Press the key to open the
MENU
2 Use the wheel to select
key
ENTER/MARK
3 Use the item to set the value.
D IMMER
Values: OFF, LOW, HIGH (default)
Restoring default settings
(INITIALIZE)
You can restore the various settings of this device
to their factory defaults.
1 Press the key to open the
MENU
2 Use the wheel to select
key
ENTER/MARK
3 Press the ≤ key at the
then press the
ENTER/MARK
mation screen.
4 Press the
ENTER/MARK
unit or press the
STOP

Formatting the SD card

There are two ways to format the SD card in this
unit: Quick Format and Full Format.
Formatting an SD card erases all audio files on
the card and automatically creates new "MUSIC"
and "UTILITY" folders as well as the "dr-1.sys"
file.
1 Press the key to open the
MENU
2 Use the wheel to select
key
ENTER/MARK
44
TASCAM DR-100
screen.
MENU
, and press the
SETUP
screen.
MENU
, and press the
SETUP
item, and
INITIALIZE
key to open a confir-
key again to initialize the
key to cancel.
screen.
MENU
, and press the
SETUP
3 Press the key at the
≤
item, and then press the
FORMAT
to open a confirmation screen.
QUICK FORMAT
FULL FORMAT
4 Press the
ENTER/MARK
or press the key to cancel.
STOP
NOTE
Use a PS-P520 AC adapter (sold separately) or be
certain that the unit has plenty of remaining battery
power when formatting. Full Format checks for
memory errors, so it takes a particularly long time
compared to Quick Format.
Setting the main battery source
(MAIN)
When both the lithium ion battery and AA
batteries are installed, you can set one as a main
power source and the other as a backup. Usually
the unit uses the main power source.
When the remaining power of the main battery
source becomes low, the unit automatically
switches to the backup, allowing continued
operation.
The battery source currently used and the amount
of remaining power it has are shown at the upper
right of the Home Screen.
1 Press the key to open the
MENU
2 Use the wheel to select
key
ENTER/MARK
3 Use the item to set the main battery power
MAIN
source.
or
QUICK FORMAT FULL
key
ENTER/MARK
screen
screen
key to initialize the unit
screen.
MENU
, and press the
BATTERY