Buss Link/Buss Pan Are Linked; Solo; Mode Select; Solo Link - Tascam DM-3200 Owner's Manual

BUSS Link/BUSS PAN are Linked

checked, this option links the buss panning when a
link is made between two busses.

SOLO

The solo modes on the DM-3200 can be set up in a
number of different ways using this screen:

Figure 2.33: SOLO options

MODE SELECT

Either
Mix Solo
be selected here. The Mix Solo
of channels (that is, all whose
solo mode) to have their outputs added together to
the solo mix. The Exclusive Solo
channel (the one whose
SOLO
to be soloed at one time.

SOLO LINK

This option allows the fader and mute
groups to be used with the solo function. This is
explained more fully in the solo part of the section
describing monitoring. Briefly, if one of the group
options ( or
MUTE GROUP FADER GROUP
selecting a group master module solos or unsolos the
whole of the group. If a group slave module is
2 – Basic operational concepts : Options
When
or can
Exclusive Solo
mode allows a number
keys are lit in
SOLO
mode only allows one
key was pressed last)
) is enabled,
selected, the solo status of only that slave module is
affected.

SOLO TYPE

There are three options that may be
selected here: (pre-fader listen),
PFL
post-fader listen) and
INPLACE SOLO
option provides a way of listening to the signal
before it is sent through the panpot and fader. The
stereo outputs are unaffected (soloing is only done
through the and
CR STUDIO
AFL selection will output the post-fader signal from
the selected channels through the monitoring system.
By contrast, soloing a channel in the
monitors the soloed signal(s) via the stereo and buss
outputs while all the other signals are cut from the
stereo and buss outputs.

INPLACE SOLO DEFEAT

option to prevent channels selected in this way from
being muted when other channels are soloed. It can
be used with a pair of effect returns, for instance, so
that these effect returns will always be added in the
inplace mix, together with those other channels
selected for inplace soloing. Inplace soloing will out-
put the soloed channel(s) from the stereo outputs, and
cut all other channels. Use the cursor keys (or chan-
nel key) to highlight a channel, and the
SEL
key to change the status of the
setting.
Alternatively, use the
SEL
direct selection and de-selection of the channels (use
to make the setting).
ENTER
TASCAM DM-3200 Owner's Manual
(after- or
AFL
. Briefly; the
PFL
monitor outputs). An
Inplace Solo mode
This option is a defeat
ENTER
INPLACE SOLO DEFEAT
keys of the modules for
35