Operation - Silvercrest SOR 2400 D2 Operating & Safety Manual

Do not use this product near a
bathtub, shower or swimming
pool.
Installation (see fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer
temperature control
Attach the U shape bolt
between first two fins with the threaded ends
pointing upward, see fig. A.
Place the U shape castor assembly
with both wheels pointing upward, see fig B,
ensure both threaded ends of U shape bolt
passing through both holes on the U shape
castor assembly
Fasten wing nut
threaded end of U shape bolt
Repeat above steps on the rear side of the
product with the I shape castor assembly
and the U shape bolt
last two fins, see fig C.
Set the product back to upright position, wheels
on the floor. It is now ready to use.
Note: The product is equipped with a tilt
protection switch. It will shut down the product
automatically if it falls over or is lying on its side.

Operation

Unwind the power cord completely from the
power cord retainer
Make sure that both, temperature control
and heat level switch
"0" respectively.
Connect the mains plug to the mains socket,
check and ensure that the mains voltage of
the mains socket meets the requirement
described in the chapter "Technical Data".
10 GB/IE/NI
upper than
7
, see fig. A.
3
to the product
10
over it
11
.
11
securely onto each
8
.
10
attached between
10
.
7
, are set to MIN and
2
Reaching the decided
room temperature
Set the temperature control
the heat level switch
indicator
1
When the desired room temperature is reached,
turn the temperature control
clockwise until the product shuts off, a "click"
sound is heard and the power indicator
goes off. Leave the temperature control
at the position and the room temperature is
now retained.
The product automatically cycles on and off
to keep the decided room temperature, the
power indicator
off to indicate when the product is heating
up. As long as the heat level switch
10
to "1"/"2"/"3", the product operates even
when the power indicator
Use the heat level switch
quickly the product shall warm up. To warm
up quickly, set the heat level switch
9
Turbo heating
To heat the room more quickly, set the
temperature control
heat level switch
indicator
1
Press the heating fan switch
"I" to switch on the heating fan. An indicator
in the heating fan switch
Hot air will be blown through the hot air
outlet .
5
To switch off the hot air outlet
heating fan switch
Using the temperature control
3
product to the desired temperature.
Switch off the product
Press the heating fan switch
to switch off the hot air outlet
to MAX. and
3
to "3", the power
2
lights up.
gently counter-
3
light also cycles on and
1
is off.
1
to select how
2
2
to MAX. and the
3
to "3", the power
2
lights up.
to position
4
will light up.
4
, press the
5
to "0" position.
4
to set the
3
to position "0"
4
.
5
1
3
is set
2
to "3".