Table of Contents
Advertisement
4 When
is lit, you can trigger flash-start
FLASH
playback from a PS/2 keyboard connected to the
front panel or from an external device connected
to the SS-R1's parallel connector.
If you're using a PS/2 keyboard, the CTRL+function
keys (F1–F12) will flash-start tracks 1–12 (see
"Keyboard operations" on page 61).
If you're using the external parallel connector, you'll be
able to flash-start tracks 1–20 (see "Control connec-
tions" on page 8).
End of disc/track message (EOM)
If the EOM function is on, an EOM tally signal will be out-
put from the
CONTROL I/O
the time remaining in the track or the play area falls below
the specified duration.
Specifying an EOM tally output trigger
Use menu mode to specify the remaining track time or
playlist time that will trigger the output of an EOM tally
signal (for details on menu operations, refer to "Operations
in the menu screens" on page 16).
1 Press the
key to access the main menu list
MENU
screen.
2 Select the PLAY menu.
3 Highlight PREFERENCE.
4 Press the front panel
˚
) key to proceed to the PLAY PREF-
¥
CURSOR
ERENCE screen.
5 Select EOM TRACK if you want to use the track
remaining time as the trigger, or EOM MEDIUM
if you want to use the remaining time in the play
area as the trigger.
Example of actual use
1 To the
(
CONTROL I/O
PARALLEL
nect the device that will receive the EOM tally
signal.
2 Power-on the SS-R1 and the receiving device.
3 Begin playback on the SS-R1.
When the remaining time of the current track or the
play area falls below the specified time duration, the
EOM indicator in the home screen will blink, and an
EOM tally signal will be output from the
O
(
PARALLEL
) connector.
(
) connector when
PARALLEL
key (or the remote's
) connector, con-
CONTROL I/
5 − Playback
NOTE
Tracks used with flash start must have the same
sampling frequency. If a track with a different
sampling frequency is detected while loading the
tracks, the display will indicate
TIP
You can make flash start settings for the desired tracks
in an efficient way by specifying the play area as
PLAYLIST and then selecting a playlist containing only
the tracks you want to flash-start. (See "Using the
playlist finder" on page 55, "Play area" on page 21.)
6 Turn the
dial (or use the remote's
MULTI JOG
keys) to specify the remaining
CURSOR
§ , ¶
time that will trigger the tally output.
You can choose from the range of
onds).
7 When you've finished making settings, press the
key to return to the home screen.
TIME (ESC)
NOTE
This setting is remembered even when the power is
off.
If the remaining time of both the track and the play area
have been specified as triggers, an EOM tally signal
will be transmitted when either condition is satisfied.
.
FLASH LOAD
or
(sec-
OFF
1 – 99
TASCAM SS-R1
Advertisement
Table of Contents
