4.5.4) Control Box
1) Attach the control box① undersurface of the table
with 4 bolts② as shown in the figure.
4.5.5) Pedal switch and connecting rod
1) Attach pedal switch ① to pedal switch bracket ②
with four bolts ③.
2) As in the Figure, attach pedal switch bracket ②
to the lower part of table.
3) Connect one end of the connecting rod ④ with
pedal switch and the other end with pedal, and
then adjust length of the rod.
4.5.6) Adjustment of Belt Tension
Remove a hand pulley and a motor cover. Loosen the
main motor bracket screw① and adjust the tension
by moving the main motor bracket from side to side.
14
②
③
②
④
①
①
①
①
②
[Fig. 4-8]
[Fig. 4-9]
[Fig. 4-10]