Operation - Makita DTP141 Instruction Manual

For tool with shallow bit hole
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
1. To install the bit, pull the sleeve and insert the bit
into the sleeve as far as it will go. Then release the
sleeve to secure the bit.
1
2
► 1. Bit 2. Sleeve
2. To install the bit, insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
1
2
3
► 1. Bit 2. Bit-piece 3. Sleeve
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
CAUTION:
• Do not touch the drill bit shortly after operating
as it gets hot. Replace the drill bit after cooling it
down.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
• After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook (Optional accessory)
► 1. Groove 2. Hook 3. Screw
CAUTION:
• When installing the hook, tighten the screw
firmly. Failure to do so may cause the breakage
of the tool or personal injury.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.

OPERATION

10 ENGLISH
1
2
3