Assembly - Ryobi GDM920 Operator's Manual

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
PACKING LIST
Garage Carbon Monoxide Alarm, Labels, and Operator's
Manual.
ACTIVATING THE BATTERIES
See Figure 1, page 17.
NOTICE:
Three Energizer Ultimate Lithium AA batteries are pre-
installed. Before first use, locate and remove the red pull
tab to activate the batteries. The battery backup feature
will not work unless the red pull tab has been removed.
NOTE: Do not operate the device without the battery cover
installed.
 Remove the red pull tab to activate batteries.
 Operate the reset/test button.
 The accessory will beep once and flash green and yellow
every two seconds for thirty seconds, then steady green
light to indicate normal operation.
NOTE: Remove the batteries for storage when device will
not be used for long periods of time.
INSTALLING/REMOVING CARBON MONOXIDE
ALARM ACCESSORY
See Figure 2, page 17.
WARNING:
This Carbon Monoxide Alarm is not intended for use
inside your house or other family living areas. It is not
designed to measure CO levels in compliance with Oc-
cupational Safety and Health Administration (OSHA)
commercial or industrial standards.

ASSEMBLY

WARNING:
This Carbon Monoxide Alarm should not be installed in
areas where the normal ambient temperature is below
-40° F (-40° C) or above 150° F (66° C).
WARNING:
Use extreme care if you need to stand on a ladder to
install or adjust this accessory. Ensure someone is hold-
ing the ladder on the ground to keep it stable. Failure to
safely use a ladder can cause a fall and result in death
or serious personal injury.
 Always refer to national and local codes before installa-
tion of any Carbon Monoxide Alarm.
 Assemble and mount the garage door opener as de-
scribed in the garage door opener manual.
WARNING:
For French and Spanish speaking customers, please
remove the English labels from the unit and replace with
the desired translated labels in the same position.
 Select one of the seven DC accessory ports to power
your Carbon Monoxide Alarm accessory.
 Slide hooks on top of accessory into the corresponding
slots on garage door opener. Push to connect accessory
latch to accessory port.
WARNING:
Ensure accessories are properly and securely connected
to their port on the garage door opener. Failure to properly
secure the accessory can cause it to fall and could result
in serious personal injury or property damage.
NOTE: Installing the Carbon Monoxide Alarm accessory
will automatically activate the port.
NOTE: For quick identification, the supplied label can
be placed over the keypad number corresponding to the
port.
NOTICE:
Your Carbon Monoxide Alarm is sealed and the cover is
not removable.
 Test the Carbon Monoxide Alarm. See TESTING YOUR
CARBON MONOXIDE ALARM section for details.
 Depress the bottom latch to release and remove the
accessory.
9 — English