Activating Programming Mode - Disty distybox 300 Operating Instructions Manual

2

2.2.1 Activating programming mode

Proceed as follows to change the distybox to programming mode:
1. Connect your telephone to the distybox.
2. Connect the power supply unit to your distybox.
3. Plug the power supply unit into a power socket. Leave the phone on
4. Lift the handset on your telephone. Depending on whether or not your
5. On your telephone, enter
6. You will hear a positive acknowledgement tone.
7. Optional step: Enter the PIN for the distybox via your telephone.
NOTE The PIN only needs to be entered if a new PIN has been set up before-
hand in programming mode.
NOTE Access to programming mode can be protected using the PIN!
8. You will hear the special dialling tone indicating that programming mo-
You can now enter the parameter codes to change the relevant features
of your distybox.
Example Let's say, for example, you want to use your distybox on a base station
with an ISDN telephone connection. Activate programming mode as des-
cribed above in points 1-8 and then proceed as follows:
1. Enter the programming code for "Connection to an ISDN/analogue Li-
2. To activate the feature, enter
3. You will hear a positive acknowledgement tone, followed by the special
Registration / programming
the hook for at least 30 seconds.
distybox is already registered on a base station, you will either hear a
busy tone or a dialling tone.
de is active.
ne" : .
4 0
dialling tone once more. The feature is now active.
.
* * 9
.
0 #
7