Registration / Programming; Automatic Registration; Programming Mode - Disty distybox 300 Operating Instructions Manual

6
NOTE
NOTE
2

Registration / programming

The distybox must be registered on your DECT/GAP base station be-
fore it can be used. The registration process can normally be carried
out using the "Automatic registration" function.
"Programming mode" allows you to set various parameters to modify
the distybox to suit the functionality of your base station. Additional
parameters allow the distybox to be set according to your personal
preferences. Manual registration can also be carried out in this mode.
2.1

Automatic registration

The distybox can be registered automatically, assuming it has not
been registered on any other base station yet. To do this, the PIN on
your base station must be set to "0000" or "1111".
1. Connect the power supply unit (adapter) to your distybox.
2. Connect your telephone to the distybox, leaving the handset on the
hook.
3. Ensure that your base station enables an additional cordless phone
to be registered.
4. During the registration process, the distybox should be located clo-
se to your base station.
5. Start the registration procedure for the device on your DECT/GAP
base station as if you were registering an additional cordless unit.
Instructions on how to do this will be given in the operating manual
for your base station.
6. Plug the power supply unit into a power socket. The registration
process will be started automatically.
7. The registration process has been successful if the LED flashes at
intervals of approx. 10 seconds.
If the registration process has not been completed successfully within
approx. 3 minutes, register the device manually in programming mode.
2.2

Programming mode

Programming mode on the distybox can only be activated within the
first 10 minutes after plugging in the power supply unit. This prevents
the parameters being changed accidentally during operation.