Trotec TTK 166 ECO Operating Manual page 7

Mounting the transport handle
Prior to initial start-up, the transport handle must be attached to
the device. To do so, please proceed as follows:
1. Loosen both screws and nuts of each of the two holders.
2. Insert the transport handle into the holder.
3. Screw the transport handle to the two holders.
4. Check the transport handle for tight fit.
EN
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
C
D
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Set the device up in an upright and stable position.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• When positioning the device, keep a sufficient distance to
heat sources.
• Make sure that no curtains or other objects interfere with
the air flow.
• When positioning the device, particularly in wet areas,
secure it locally with an RCD (residual current device)
which complies with the respective regulations.
• Do not incline the device by more than 45°, for otherwise
the device could be damaged.
dehumidifier TTK 166 ECO
A
B
C
7