Trotec TTK 166 ECO Operating Manual page 6

Assembly
Use tools suitable for the intended task.
Mounting the foot
The foot must be attached to the device prior to initial start-up.
To do so, please proceed as follows:
1. Place the device on its front side.
2. Mount the foot to the front bottom side of the device using
the four small screws.
Mounting the wheels
Prior to initial start-up, the transport wheels and the axle must
be attached to the device. To do so, please proceed as follows:
ü The device is placed on its front side.
1. Use the four large screws to fasten the axle to the rear
bottom side of the device.
2. Attach the two wheels to the axle.
3. Attach the two washers to the axle.
6
4. Screw the two nuts to the axle.
5. After mounting the wheels and the feet, place the device in
an upright position.
Note
Leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor.
Wait 12 to 24 hours before switching the device back
on! Acting contrary might lead to compressor damage
and a malfunctioning device. Any warranty claims will
be voided in this case.
dehumidifier TTK 166 ECO EN