Follett T400A Installation, Operation And Service Manual page 16

Additional ice transport tube connection specifications for Vision series ice and beverage dispensers
Check to make sure bin signal on ice machine control board is switched to 24 V connection.
1. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.
2. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice
transport tube(s) (see drawings below).
3. Verify bin thermostat capillary tube is mounted correctly (see drawings below).
Ice tube retainer bracket
ice tube
Bin thermostat capillary tube mounting
Front View, VU155
thermostat
tabs in ice tube
retainer bracket
ice tube
engage holes in ice
tube and hold tube
in place
16 T400A/W, MCD400A/W, R400A/W, MFD400A/W, D400A/W Ice Machines
1" (26 mm)
ice tube
retaining
bracket
thermostat
ice tube
retaining
bracket
ice tube
Front View, VU300
ice tube
ice tube
retaining
bracket
thermostat