Follett T400A Installation, Operation And Service Manual page 12

Step 2 – Installing RIDE model ice machine on slide-out track
counter front
grille supplied with air-
cooled RIDE model ice machines
bin signal cord
(icemaker connection)
(air-cooled units only)
A. When ice machine is shipped with slide-out track accessory (follow either A or B)
1. Connect inlet water, drain, and power supply to back of vertical utility panel.
2. Place ice machine on slide-out track assembly.
3. Connect drain and water lines.
4. Connect electrical plugs from ice machine to utility panel.
B. When ice machine is installed in and shipped with counter
1. Remove two outer rear screws from ice machine and install supplied spacer and screw (Fig. 3).
2. Place ice machine on slide-out track assembly.
3. Connect drain and water lines.
4. Connect electrical plug from ice machine to utility panel.
5. Remove pin from adjustable leg.
6. Place hold-down strap over leg block and secure strap to slide-out assembly with supplied screws (Fig. 4).
7. Reinstall pin in leg block.
8. At job site remove hold-down strap and make utility connections at rear utility panel.
Fig. 3
12 T400A/W, MCD400A/W, R400A/W, MFD400A/W, D400A/W Ice Machines
air in
Remove screw. Install
supplied screws and spacers.
position track accessory so that 2" (51mm) duct
supplied with air-cooled RIDE model ice machine mates
with back of counter opening.
Fig. 4
hold-down strap
(for installation; remove
and discard)
power cord
bin signal cord
(customer connection)
Supplied screws (for installation;
remove and discard)