Connecting To The Datport Command Interface Using Telnet - TANDBERG GW Dataport Command Interface D13202 User Manual

TANDBERG GW Dataport Command Interface User Guide
3.

Connecting to the Datport Command Interface using Telnet

The TANDBERG GW has two LAN ports. Connection to the Dataport Command Interface
via Telnet should be done through LAN port 1.
The GW's Telnet server provides access to the Dataport Command Interface through a 10/100
base T network interface supporting the TCP/IP protocol.
When connected to the GW, the Telnet client will receive a welcome message similar to the
following:
Welcome to TANDBERG
TANDBERG GW Release G1.0
SW Release Date: 2003-07-01
NOTE! If the TANDBERG GW is protected by an IP password you will be prompted to enter
this password before you can access the Dataport Command Interface via Telnet.
D13202 Rev 01 6