Parameter Storage - TANDBERG GW Dataport Command Interface D13202 User Manual

TANDBERG GW
4.3.

Parameter Storage

Parameters are set by issuing Parameter Setting Commands, ref. chapter 4.1.2.
All parameters and their corresponding storage type are listed in the table below. The following
definitions are used:
level 0: No storage (RAM). Does not survive boot or any of the "defvalues" combinations.
level 1: Normal storage (EEPROM). Survives boot, but none of the "defvalues" combinations.
level 2: Normal storage (EEPROM). Survives boot and "defvalues set". Does not survive
"defvalues set all".
level 4: Survives everything, except software upgrade and "defvalues set factory".
Command
directory
gwdid
gwextdialin
gwh323service
gwhotline
gwloadlimit
gwsettings
h323alias
h323gatekeeper
ipaddress
ipassignment
ipmtu
ippassword
ipqos
ipspeed
isdnprot
netprofile
optionkey
pardial
pricable
prichan
pricrc4
prinet
protect
sendnum
services
snmp
sport
systemname
*Except sub command sendcomplete: level 1
D13202 Rev 01
Dataport Command Interface User Guide
Storage
level 1
level 2
level 2
level 2
level 2
level 2
level 2
level 2
level 2
level 2
level 2
level 1
level 2
level 2
level 2
level 2*
level 2
level 2
level 1
level 2
level 2
level 2
level 2
level 4
level 1
level 1
level 2
level 2
level 2
31