Table of Contents
Advertisement
TANDBERG GW
*P services http on
*P services https on
*P services snmp on
*P services ftp on
Enables/disables broadcast of the local unit's number during H.320 call setup.
sendnum
NOTE! The transfer of the local number to a remote system or the prevention
thereof is dependent on the feature set supported by the network or networks
between the GW and the endpoint.
sendnum <on/off>
---
Example of sendnum feedback:
*P sendnum on
Configures the snmp mib.
snmp
Note! For more information about SNMP please read the TANDBERG SNMP
application note.
snmp cn <community name>
or
snmp sc <system contact name>
or
snmp sl <system location name>
or
snmp hi <host ip address.> [host ip address] [host ip address]
---
parameters:
sub-commands:
Example of snmp feedback:
*P snmp hi 10.0.2.255 "" ""
*P snmp sl ""
*P snmp sc TANDBERG
*P snmp cn public
This command is used to configure the serial port by setting baudrate, parity,
sport
databits and stopbits.
sport [baudrate] [parity] [databits] [stopbits]
---
parameters:
D13202 Rev 01
community name: Textstring of maximum 16 characters.
system contact name: Textstring of maximum 50 characters
system location name: Textstring of maximum 50 characters
host ip address: ip address
cn: Used to set the community name parameter.
sc: Used to set the system contact name parameter.
sl: Used to set the system location name parameter.
hi: Used to set the host ip address parameters.
baudrate: 1200/2400/4800/9600/19200/38400/57600/115200
parity: n/o/e
databits: 7/8
stopbits: 1/2
Dataport Command Interface User Guide
16
Advertisement
Table of Contents
