TANDBERG GW Dataport Command Interface D13202 User Manual page 20

TANDBERG GW
gwh323service <id> servprefix <e164prefix>
or
gwh323service <id> maxbw <bw>
or
gwh323service <id> isdncallprefix <callprefix>
or
gwh323service <id> restrict <on/off>
or
gwh323service <id> description <description>
parameters:
sub-commands:
gwhotline Hotline numbers are used to map an incoming ISDN number to an h323 number.
gwhotline <id> isdnnumber <isdnnumber>
or
gwhotline <id> h323alias <E164alias>
or
gwhotline <id> maxbw <bw>
or
gwhotline <id> description <description>
parameters:
sub-commands:
NOTE! Only one hotline entry is supported in this version of the TANDBERG GW.
The GW will signal busy to the gatekeeper when the current load on the GW reaches
gwloadlimit
this limit.
The current system load can be monitored by the status command systemload.
gwloadlimit <0..100>
To avoid interoperability problems, the GW can be configured to not support some
gwsettings
features.
gwsettings natvid <on/off>
or
gwsettings customformats <on/off>
D13202 Rev 01
id: 1..20. Identificator referring to a specific h323service.
bw: 64/128/192/256/320/384/512/768/1152/1472/1920
servprefix: Sets the service prefix for this h323 service.
maxbw: Sets the maximum bandwidth to be used when setting up a GW
call using this h323 service.
isdncallprefix: Defines an isdn call prefix to be added to the ISDN number
to dial.
restrict: Sets restrict to on or off.
description: To set an informative text for this h323 service.
id: 1. Identificator referring to a specific hotline entry.
bw: 64/128/192/256/320/384/512/768/1152/1472/1920
isdnnumber: Defines the hotline ISDN number.
h323alias: Defines the corresponding h323 number for this hotline entry.
maxbw: Sets the maximum bandwidth to be used when setting up a GW
call using this hotline.
description: To set an informative text for this hotline entry.
Dataport Command Interface User Guide
20