Installing The Wheel; Installation - Thrustmaster T80 Ferrari 488 GTB Edition Manual

INSTALLING THE WHEEL

Attaching the wheel to a table or desk
- Place the wheel on the edge of a table or other flat surface.
- Place the fastening screw (11) inside the table/desk mounting system (12), and screw the unit
(counterclockwise) into the large screw thread on the underside of the wheel, until the wheel is perfectly
stable.
WARNING: Never attempt to screw in the fastening screw (11) without the table/desk

INSTALLATION

Turn the fastening screw (11)
counterclockwise
Connecting the pedal set to the wheel
Connect the pedal set male connector (8) to the wheel's female connector (9), located at the back of the
wheel's base.
mounting system (12) in place!
(Doing so may damage your wheel.)
To tighten:
REMOVAL
To untighten:
Turn the fastening screw (11)
clockwise
3/8