Maintenance - Husqvarna R 318X AWD Operator's Manual

Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
Clean the product
Clean the inner surface of the cutting deck, around the blades
Clean around the muffler
Examine the muffler to make sure that it is attached correctly and
not damaged
Make sure that the cold air intake of the engine is not blocked
Make sure that the safety devices are not defective
Do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Make sure that the headlight operates correctly
Examine the blades in the cutting deck
Make sure that the tire pressure is correct
Replace the engine oil
Replace the oil filter
Clean the air filters
Replace the air filters
Replace the fuel filter
Replace the spark plug
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster.
18
Maintenance
X = The instructions are given in this operator's manual.
Note: If there is more than 1 time interval for a task, the
shortest time interval is for the first maintenance. After
the first maintenance, obey the longer time interval.
Maintenance schedule
Daily maintenance
before operation
Maintenance interval
in hours
25 50
*
*
X
X
X
X
X
X
X
X
X
X
X X
X X
X X
X
X
X
X X
X
X X
X X
838 - 005 - 21.10.2019
100 200
X
X
X
X