Husqvarna R 318X AWD Operator's Manual page 15

4. To adjust the seat springs, move the 2 rubber stops
below the seat as given in the illustration. Put the 2
rubber stops in the front, middle or rear holes below
the seat.
To adjust height of the steering wheel
WARNING: Do not adjust the height of the
steering wheel during operation of the
product.
1. Turn the knob counterclockwise to loosen.
2. Adjust the height of the steering wheel.
3. Turn the knob clockwise to tighten.
CAUTION: Make sure that the long end of
the knob points up.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
838 - 005 - 21.10.2019
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever for model R 318X is found
behind the left rear wheel. Model R 320X AWD has one
drive system lever for the front and one for the rear axle.
The drive system lever for the rear axle is found behind
the left rear wheel.
The drive system lever for the front axle for R 320X
AWD is found behind the left front wheel.
To lift and lower the cutting deck
To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
15